DC Average between Cursors

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
JohnDSutter
Newbie
Posts: 0
Joined: Thu Jan 08, 2015 1:34 am

DC Average between Cursors

Post by JohnDSutter »

I don't seem to understand how to take a "DC average" measurement "between cursors".
When I set the cursor along the bottom to the region I am interested in, I get nothing.
If I change the measurement to the whole waveform it is fine.

I am running the latest version.

The cursors are showing 0 and 360 degrees as opposed to delta t as I would have expected.

Any ideas what I am doing wrong?

- John

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: DC Average between Cursors

Post by Martyn »

You have pulled in the Phase Rulers from the right hand side. The cursors are located at the bottom left of the screen, the little white square.
Martyn
Technical Support Manager

JohnDSutter
Newbie
Posts: 0
Joined: Thu Jan 08, 2015 1:34 am

Re: DC Average between Cursors

Post by JohnDSutter »

Didn't even see those. Thanks much!

- John

Post Reply