Scaling of Y-axis in software V6.9.14.16

[Picolor]

We only need positive voltages, but the software only displays the half of the disposal surface.
One half is positive and the other half is negative. When we scale it, that the zero point is below, the 20V point is in the half of the display and the other half is unused. Is it possible to display only positive voltages over the complete surface?

regards
thomas

[bennog]

If you press the blue rectangle on the bottom left (with the x1.0 in it)
You can set the settings like below and you can use the full screen (you only use 7 of the 8 bits) or (11 of the 12) depending on the scope you use.
Scale 2.0

Regards,
Benno