Scaling on graphs

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
pwright
Newbie
Posts: 0
Joined: Mon Sep 16, 2013 11:10 am

Scaling on graphs

Post by pwright »

Hi,

I've continued some testing from a few months back with the same gear and have got very different answers. This time I created a custom probe to output my results directly in kN. Last time I left them in V (converting later), but I think I may have used x100 probe. Is there anyway I can confirm this from the .psdata file graph? e.g. the resolution?
Thanks
Phil

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Scaling on graphs

Post by Martyn »

If you open up PicoScope 6 and then load the psdata file and take a look at the probe it should tell you what was used when the readings were taken.
Martyn
Technical Support Manager

Post Reply