Function generator frequency range is not DC to 100KHz

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Delv31
Newbie
Posts: 0
Joined: Wed Oct 24, 2012 11:51 am

Function generator frequency range is not DC to 100KHz

Post by Delv31 »

hello,
i'l using picoscope with Function generator.
in description i can see :
Function generator frequency range DC to 100KHz but i can't operate ( arbitrary import) under 30mHz.
Is it possible to adjust under 30mHz?

Thanks for reply.

Hitesh

Re: Function generator frequency range is not DC to 100KHz

Post by Hitesh »

Hi,

Which PicoScope device are you using?

Thanks,

Delv31
Newbie
Posts: 0
Joined: Wed Oct 24, 2012 11:51 am

Re: Function generator frequency range is not DC to 100KHz

Post by Delv31 »

Good morning,
i'm using 4227 picoscope.

vincent Delv

Hitesh

Re: Function generator frequency range is not DC to 100KHz

Post by Hitesh »

Hi Vincent,

This is a limitation of PicoScope 6.

If you use the Software Development Kit, you should be able to achieve frequencies below 30mHz.

Hope this helps.

Delv31
Newbie
Posts: 0
Joined: Wed Oct 24, 2012 11:51 am

Re: Function generator frequency range is not DC to 100KHz

Post by Delv31 »

Hi,
Ok i'm going to use Software Development Kit.
is it expected to adjust Function generator frequency range DC to 100KHz in future version of picoscope 6 ?

Thanks,

Delv Vincent

Hitesh

Re: Function generator frequency range is not DC to 100KHz

Post by Hitesh »

Hi Vincent,

I think this will remain the same - I suspect it is due to the way the AWG is implemented.

Regards,

Delv31
Newbie
Posts: 0
Joined: Wed Oct 24, 2012 11:51 am

Re: Function generator frequency range is not DC to 100KHz

Post by Delv31 »

Hi,
Thanks for reply.

Vincent.

Post Reply