Hi,
I'm trying to use PWM1 and PWM2 of the USB DrDAQ writing my own programs using the SDK. To be able to control motors using H-bridges, I need to raise the voltage level of the PWM signal from about the 0-2V to meet the logic level 0-5V of the H-bridges. so I need some information about the o/p circuit of the PWM. Is it safe to connect a pull-up resistor to the o/p?
Are there any alternative solutions?
Regards.
USB DrDAQ PWM
Re: USB DrDAQ PWM
You will need to amplify the output of the DrDAQ it is a low level signal, pull-up's wont work.
Martyn
Technical Support Manager
Technical Support Manager
Re: USB DrDAQ PWM
Hi,
PWM supposed to be a digital signal (on/off) not an analog signal isn’t it?
Analog signals need amplifier if they are small signals; digital signals need a level converter.
I need to know the output circuitry of USB DrDAQ to apply a suitable conversion circuit to it.
Regards.
Yasser
PWM supposed to be a digital signal (on/off) not an analog signal isn’t it?
Analog signals need amplifier if they are small signals; digital signals need a level converter.
I need to know the output circuitry of USB DrDAQ to apply a suitable conversion circuit to it.
Regards.
Yasser
-
- Site Admin
- Posts: 78
- Joined: Tue Jun 30, 2009 3:08 pm
Re: USB DrDAQ PWM
Hi There,
One option would be to use an NPN transistor. Simple and effective.The silicon transistor was invented in 1954 and has been considered one of the greatest inventions in the history of technology. In terms of using the PWM function of DR Daq you could connect the base to the PWM OUTPUT( signal voltage), choose a value of resistor suitable for connecting to the +Ve rail ( 1 K ), connect the emitter to negative (ground) the result collector output will be inverted.
Hope this helps,
Have a great weekend.
Kindest regards,
Stuart
Technical Specialist
One option would be to use an NPN transistor. Simple and effective.The silicon transistor was invented in 1954 and has been considered one of the greatest inventions in the history of technology. In terms of using the PWM function of DR Daq you could connect the base to the PWM OUTPUT( signal voltage), choose a value of resistor suitable for connecting to the +Ve rail ( 1 K ), connect the emitter to negative (ground) the result collector output will be inverted.
Hope this helps,
Have a great weekend.
Kindest regards,
Stuart
Technical Specialist
Re: USB DrDAQ PWM
Hi Pico Stuart,
Thank you for your reply. You gave me a nice inexpensive solution.
Although I wanted to understand the o/p circuitry of DrDAQ.
Thanks again.
Yasser
Thank you for your reply. You gave me a nice inexpensive solution.
Although I wanted to understand the o/p circuitry of DrDAQ.
Thanks again.
Yasser
Re: USB DrDAQ PWM
We do not divulge our IP so we can't provide you with this detail.
Martyn
Technical Support Manager
Technical Support Manager
Re: USB DrDAQ PWM
no problem.. thanks any way.