adc200_set_trigger & LabView 6.1

Post general discussions on using our drivers to write your own software here
Post Reply
dcf

adc200_set_trigger & LabView 6.1

Post by dcf »

I have just started developping a program with LabView 6.1, Pico ADC 212/50 and WIN98. I need to use the trigger function, but in the exemple file 'adc200.vi' there are not examples about it. I' ve tried to set up a function call to 'adc200_set_trigger' in the 'adc20032.dll', but I'm not shure I've set up parameters correctly: when I run it LabView crashes.
There is a place where I can find more examples, or anybody can give me any suggestions?

Thanks in advance.

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

Unfortunately, we do not have any other examples with triggering incorporated. However, if you look at the C example this has got the trigger function being used. It will demonstrate the order calls have to be made in and the paramerter types.

Perhaps someone else on the forum can provide you with an example.

Best regards,
Regards,

Mark Spencer

eeniu@hotmail.com

Triggering in Labview\ adc200_set_trigger

Post by eeniu@hotmail.com »

I was wondering if dcf fixed the problem because it seems that i am haveing the same problem. If you could pleace post or send me an example of triggering in labview

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

I have recently tried the triggering and not had any problems, if you send an email to:

tech@picotech.com

Requesting adc200t.zip file. I will then dispatch it to you.

Best regards,
Regards,

Mark Spencer

Post Reply