I need to read frequency to 1Hz the current display reads 65.53KHz how do i get the extra digit?
I.e. i need it to read 65.536KHz
Is there an option to set the number of digits displayed anywhere
Thanks
Angus
Hi Angus,
Thank you for your suggestion, however this is not something that we will be implementing in the near future. I have forwarded your suggestion to our developers.
I've requested a similar change before. With the 4262, you have 16-20bit resolution, but only 4 digit readout. All that resolution is just wasted in this case. Making the readout digits adjustable should be a no brainer, my handyscope has it since 2005.
Martyn wrote:Frequency measurement can be performed using Maths Channels for all scopes, or in hardware on one channel for some scopes in the 4000 range.
selecting freq and the channel that you wish to look at. When set up make sure you tick the newly created channel and then apply and it will appear on screen.
Unfortunately that is currently the best that can be achieved using the PicoScope6 software. The alternative would be to write your own application using the sdk and perform frequency counting in code.