feature request: measure Left-Right

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
dat
Newbie
Posts: 0
Joined: Wed Dec 07, 2011 4:21 am
Location: Florida, USA

feature request: measure Left-Right

Post by dat »

Could you please add an option to the measurement types: Subtract the Left sample value from the Right? I think that this should be easy to do. Using "Between Rulers" as the section of the graph would then give an easy way to accurately determine the voltage difference between two points of the sampled waveform.

Martyn
Site Admin
Site Admin
Posts: 3833
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: feature request: measure Left-Right

Post by Martyn »

Thank you for your input I will pass this suggestion through to the development team.
Martyn
Technical Support Manager

Martyn
Site Admin
Site Admin
Posts: 3833
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: feature request: measure Left-Right

Post by Martyn »

You could achieve this by using both the vertical and horizontal rulers.
Martyn
Technical Support Manager

Post Reply