temp measurement with adc 24bit

Post any questions you may have about our current range of USB data loggers
Post Reply
Posts: 0
Joined: Wed Jan 18, 2012 1:23 pm

temp measurement with adc 24bit

Post by crotty » Wed Jan 18, 2012 1:34 pm

I am new on this post.....
I have an adc 24 bit and wish to measure temps along side (in time ) the pressure I measure. I use the terminal board supplied with the adc. What and how do/can I connect.

Advanced User
Advanced User
Posts: 2856
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: temp measurement with adc 24bit

Post by Hitesh » Thu Jan 19, 2012 12:20 pm

Hi Crotty,

With an ADC-24, you would be looking at using thermistors to measure temperature.

Please refer to the terminal board user guide http://www.picotech.com/document/pdf/ad ... uide-5.pdf. Section 2.5 deals with measuring temperature.

You would need to connect the wire supplying the measurement to one of the channels, and the other to the analogue ground terminal on the board.

For sensors with voltages beyond the +/-2.5V range use a voltage divider connection on the terminal board.

I hope this helps.


Software Dev. Engineer

Post Reply