DC rectifier values

glennsklar · Post by **glennsklar** » Sun Feb 08, 2004 10:38 pm

Please suggest the product needed to record the following data:

: DC current vs time (sec), and voltage vs. time (sec), simultaneously.

: Pulsed DC current vs time (millisecond), and pulsed voltage vs time (millisecond), simultaneously.

: Verification of rectifier pulsed output in the millisecond range by oscilliscope.

Thank You.

markspencer · Post by **markspencer** » Mon Feb 09, 2004 11:43 am

Hi,

Thank you for your enquiry.

Unfortunately, I cannot recommend or units for this, as the samples for different channels cannot be guaranteed to be taken at the same time.

Best regards,
Mark S.

Guest · Post by **Guest** » Fri Mar 26, 2004 2:57 pm

I have a similar application but with larger timescales, to what extent are samples of different channels likely to be "out of sync" ? Can your devices be configured to act as a virtual chart recorder ?

Ian Meredith

markspencer · Post by **markspencer** » Mon Mar 29, 2004 8:14 am

Hi,

Thank you for your question.

Unfortunately, I am unable to state an exact time that the channels are our of sync. It could be milliseconds, it is dependent on own the software collects the data.

Picolog can be used in place of a chart recorder. A graph of each channel can be produced from the data and the readings viewed in a spreadsheet.

I would advise downloading the demo software, just follow the download link.

Best regards,