PicoScope 7 Software
Available on Windows, Mac and Linux
Streaming from two 4824As simultaneously
-
DanielBorg
- Newbie
- Posts: 1
- Joined: Sun Feb 11, 2024 10:26 am
Streaming from two 4824As simultaneously
Hi!
I would like two use two 4824A to simultaneously acquire 16 channels.
The trace length would be about 50-100 µs and will be acquired as fast as possible.
At 80MS/S each trace should be 4000-8000 samples.
The signal to acquire is repetitive with 8 Hz so I would like to acquire about 64 waveforms to average.
Since the 4824 itself cannot perform on-board averageing, I will need to stream the data to LabView and do the averaging when acquisition is finished. With 8 Hz repetitive rate I need to transfer 64k samples from each oscilloscope every 125 ms.
Would two 4824As be a good solution to do this?
Best regards
I would like two use two 4824A to simultaneously acquire 16 channels.
The trace length would be about 50-100 µs and will be acquired as fast as possible.
At 80MS/S each trace should be 4000-8000 samples.
The signal to acquire is repetitive with 8 Hz so I would like to acquire about 64 waveforms to average.
Since the 4824 itself cannot perform on-board averageing, I will need to stream the data to LabView and do the averaging when acquisition is finished. With 8 Hz repetitive rate I need to transfer 64k samples from each oscilloscope every 125 ms.
Would two 4824As be a good solution to do this?
Best regards