Position Adjust

[bartj]

In looking over the programmers manual it appears that there is no way to adjust the vertical offset (position) of a signal. Presently we use low end tek scopes and am able to adjust vertical offset to allow optimal dynamic range when making measurements on bi-phasic waveforms.

Can I assume that the 2200 series does not allow for programmable offset control?

Thanks,
bartj

[Robin]

That's correct. The voltage ranges that can be selected are the ones shown below. You select the voltage range when you call ps2000_set_channel

±50 mV
±100 mV
±200 mV
±500 mV
±1 V
±2 V
±5 V
±10 V
±20 V

Robin