Post any questions about our parallel port products
I intend to run two ADC11's on LPT1 & LPT2.
I need to know the sequence to switch them alternately so as to maintain an uninterrupted sampling cycle.
i.e Do I use adc11 open/close unit or do I leave both units open and use adc11 get unit?
- Site Admin
- Posts: 598
- Joined: Wed May 07, 2003 9:45 am
To use more than one unit open them both and then use the function:
All subsequent calls will be made to the unit referred to in that function until there is another call changing the focus to another unit.