adc-212 single shot trigger

Post any questions about our parallel port products
Post Reply
wozencroftm
Newbie
Posts: 1
Joined: Wed May 13, 2009 9:58 am

adc-212 single shot trigger

Post by wozencroftm »

Hi,
I am trying to capture a single shot sine wave superimposed on 2.5V dc
The sine wave has a period of 0.6sec and a peak value of 1.7V.
If I set trigger threshold to 3V.
Triggers ok with time-base of 100ms. If I increase timebase to get a better display signal just scrolls on left.
thanks
Martin

Robin
Advanced User
Advanced User
Posts: 558
Joined: Fri Sep 19, 2008 10:17 am

Post by Robin »

Hi

Go to settings->options->advanced. You can then change the slow sampling mode to either block or standard. In block mode, the whole waveform will be collected before being displayed.

I hope this helps

Robin

Post Reply