WORKING WITH MULTIPLE CONVERSORS

Which product is right for your exact requirements
Post Reply
JGARCIA

WORKING WITH MULTIPLE CONVERSORS

Post by JGARCIA »

Dear sirs:

When you work with two different conversors, is it possible to calculate a parameter taking data from both conversors? For example, if I had a TC-08 with 8 termocouples and an ADC-16 with 8 channels measuring voltage, could I calculate a parameter combining the data given by TC-08 channel 1 and ADC-16 channel 1?

Thank you very much in advance.

Best regards,

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

It is possible to use calculated parameters with values taken from one channel of a TC-08 and another from ADC-16.

Settings | Calculated Patameters

Select the TC-08 channel for A and ADC-16 channel for B, the order here does not matter.

Now enter the mathematical formula in the box below and if you want to se the units click on options and complete this part too. Click ok and the calculated parameter will be displayed in the recorder window, similiar to a channel.

Best regards,
Regards,

Mark Spencer

Post Reply