2104 broken

[pficheux]

Hi,

When removing the yellow plug from my Pico 2104, I disconnected the white wire (should be the signal wire).

How to reconnect (solder) it to the PCB ?

Thx

[Gerry]

Hi pficheux,

Could you contact our helpdesk (support@picotech.com) where one of our technical specialists will be able to help you.

Regards,

Gerry

[pficheux]

Hi Gerry,

Helpdesk proposed to send the device but it should be possible to solder it by myself (where to connect the white wire...).

regards

[Martyn]

Can you see the other end of the broken white wire on the PCB ? Looks like there may be some glue holding it there.

[pficheux]

I don't see anything but I assume you have the tech doc and schematics at Picotech

[Martyn]

Can you see the notch in the PCB at the top of the picture with what looks like clear glue holding a white wire?

[pficheux]

Hi,

I didn't see any picture but problem is fixed, was very easy

regards

[pficheux]

On the road again