Setup the Pico 4262 signal generator to output: 1.228 VAC @ 400 Hz with the source (load) impedance of 150 ohms

[grievousangel]

I need to setup the Pico 4262 signal generator to output: 1.228 VAC (+4dbu) @ 400 Hz with the source impedance of 150 ohms. Output appears to in 1V intervals unless below 1V, then 100 mV intervals.

Can I set 4262 signal gen to output dbu, say +4dbu? Is it possible to set a load impedance, say 150Z or 600Z?

If not in the current Version 6, can it be added in next release? Has anyone written code to do this? In the audio world, this would seem to be a popular need.

Cheers,

Billy

[Gerry]

Hi Billy,

Please review the answer on your previous post.

Regards,

Gerry