PicoScope 7 Software
Available on Windows, Mac and Linux
PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code
PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code
Hi,
I am using a PicoScope 5242B. I want to get it running on Labview (2018 version) so I thought this example program (Title) would be a good place to start. I believe I have the ports and USB power configured properly, since the error messages (5003 and 5282) no longer appear when I press run.
When I run the program, it starts with a 'PicoScopeR' loading screen. When it fully loads, the program stops automatically. No error code appears. I want it to run continuously and display the signal, so I'm not sure what I'm doing wrong.
The test signal I'm transmitting is 350Hz sinewave@1V.
P.s. I am able to confirm this signal is received by viewing it on PicoScope 6. I exit PicoScope 6 before running the Labview program.
Thank you for reading, any help appreciated
I am using a PicoScope 5242B. I want to get it running on Labview (2018 version) so I thought this example program (Title) would be a good place to start. I believe I have the ports and USB power configured properly, since the error messages (5003 and 5282) no longer appear when I press run.
When I run the program, it starts with a 'PicoScopeR' loading screen. When it fully loads, the program stops automatically. No error code appears. I want it to run continuously and display the signal, so I'm not sure what I'm doing wrong.
The test signal I'm transmitting is 350Hz sinewave@1V.
P.s. I am able to confirm this signal is received by viewing it on PicoScope 6. I exit PicoScope 6 before running the Labview program.
Thank you for reading, any help appreciated
Re: PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code
Hi, Could you please email support@picotech.com
And supply following details-
Is this the 32-bit or 64-bit version of LabVIEW? And are you using the 32 or 64-bit version of the code?
What version of the SDK do you have installed?
Are you using the default settings on the front panel? Or have you changed these.
What version of windows are you running?
And supply following details-
Is this the 32-bit or 64-bit version of LabVIEW? And are you using the 32 or 64-bit version of the code?
What version of the SDK do you have installed?
Are you using the default settings on the front panel? Or have you changed these.
What version of windows are you running?
Regards Andrew
Technical Specialist
Technical Specialist