use 6404C waveform generator in labview

[nl5hucd]

i'd like to use the waveform generator on the rear of the 6404C
to trigger an external circuit.

please advise on what parts of the sdk to use?

i have the picoscope and the picoscope6000 dll files but i do not see the correct VI.

[Martyn]

Please check the LabVIEW examples for the 6000 series on our GitHub Page

[nl5hucd]

Hi Martyn,

thank you. i do not have access to the pico6000awg.vi

i am trying to run the executable for the 32-BIT SDK and it is not working.

[Martyn]

All the SDK installer does is to install the driver and library files to allow the scope to be accessed, it does not install any programmes that will run. If the SDK install runs then you should be able to download the VI's from GitHub and they should work.

Please note that you need the SDK and examples to match the version of LabVIEW you have, either 32bit or 64bit.