We had purchased TA300 Current probe alongwith the Pico 4444 oscilloscope. We would like to connect the Current probe with other datalogger and to do the same we need the Pinout details of Picolog. Can you share the same please?
Thanks for your feedback.
We are not in position to buy the other current probes. We need your support
We saw in the datasheet that the sensitivity is informed as 100mV/A and it requires 5V DC for operation. So we hope that we could acquist the feedback voltage from the current probe with external logger.
It is not hard to figure out how the 4444 probe detection and powering works.
I did it 2 years back just out of curiosity how the 4444 knows witch type of probe is connected.
Don't know if I can post my findings without my post being removed.
Please note that if you create your own probes and subsequently cause damage to the scope this will not be covered by any warranty. If you go down this route make sure you fully understand what you are doing and how it works.