Hi,
a bit new to this so I may be posting in the wrong section but please bear with me...
I am measuring thermal points (8 off) on a system and I really would like to add extra functionality.
Ideally I would like to vary the input voltage and current and still monitor the temperature but all automatically.
Is there a function on the pico software to take a reading and then increase/decrease the power supply prior to taking another reading or will Ihave to run 2 bits of software?
Ideally the one would be best so I could integrate the voltage/Current readings together with the temperature nodes.
Cheers for any help.
Spence
full system control
Hi Robin,
Sorry for not being too precise......
I have a product I have designed that I wish to leave on test for a long period of time.
I will thermocouple this device up and start to log this information but I will also need to vary the input voltageand also the current to my design and monitor the thermals under the new conditions.
I can do this manually but I have a programmable power supply which I would also like to have some control over and what a fantastic way to do it and integrate it with the thermal measurements.
Your input is valued.
Regards,
Spence
Sorry for not being too precise......
I have a product I have designed that I wish to leave on test for a long period of time.
I will thermocouple this device up and start to log this information but I will also need to vary the input voltageand also the current to my design and monitor the thermals under the new conditions.
I can do this manually but I have a programmable power supply which I would also like to have some control over and what a fantastic way to do it and integrate it with the thermal measurements.
Your input is valued.
Regards,
Spence