ETS trigger

Forum for discussing PicoScope (version 5)
Post Reply
jswanson
Active User
Active User
Posts: 14
Joined: Wed Apr 05, 2006 8:07 pm

ETS trigger

Post by jswanson »

I have a problem with ETS on an ADC212/50. If I set the TB to 1us (fastest non-ets) then change to ets the dispay shows what i would expect. If I change the TB the display looses resolution to the non-ets maximum. If I change the TB back to 1us the resolution is still not there. To get ets to work again I have to change the TB to Repeat, change the TB to another value and back again then select ETS. The attached files show the difference. What is happening?
Attachments
2008_09_24_002.jpg
(58.74 KiB) Downloaded 85 times
2008_09_24_001.jpg
(52.95 KiB) Downloaded 79 times

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi jswanson,

What version of the software are you using?
What kind of signal have you got going in?

Kind regards
Ziko

Technical Specialist

Guest

Post by Guest »

5.20.1

The input is a pulse 70us wide @ 100Hz.

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi jswanson,

I have managed to recreate your test set-up and problem I have reported it as a bug report.

Kind regards
Ziko

Technical Specialist

Post Reply