Hi,
I have a problem with the trigger of the ADC-212/100:
So when I set the trigger to 1ms/unit everything works fine, but i need a unit about 1us/unit. The triggger doesn't work. The trigger doesn't starts at 1V, it starts when i press the "go" button directly. Can everyone tell me what is wrong: here are my settings:
direction: increasing
trigger item: 1000 mV
stop after trigger
no ETS
Thanks for help
Trigger ADC-212/100
Hello Oesi,
What is the frequency of your rectangle? Does it have 1:1 markspace:space?
Perhaps you could send a copy of your data file and settings file to support@picotech.com so that we may take a look.
Regards
John
What is the frequency of your rectangle? Does it have 1:1 markspace:space?
Perhaps you could send a copy of your data file and settings file to support@picotech.com so that we may take a look.
Regards
John
Hello Oesi,
I believe that the problem may lie in what you are trying to do:
If you set the timebase to 1 uS per division, then you have less than 10 uS in which to capture the trigger event on screen.
It is possible that the response time of your 'trigger system' is just not capable of operating that fast.
Regards
John
I believe that the problem may lie in what you are trying to do:
If you set the timebase to 1 uS per division, then you have less than 10 uS in which to capture the trigger event on screen.
It is possible that the response time of your 'trigger system' is just not capable of operating that fast.
Regards
John