Forum for discussing PicoScope (version 5)
4 posts • Page 1 of 1
Hello. I'm using Picoscope 5.19 with my 212/3. The setup is scope on ch. A and meter on ch. B. It seems the meter will only update in Block Mode but this is reducing the scope scan to 4 seconds and I am wanting a timebase of 20 seconds. The scope will scan 20 seconds in Standard or Chart Recorder but then the meter will not update. Any ideas?
Hello Ziko. Thanks for your reply. Take a look at these two files; Meter Updates 1 & 2. The meter updates at those timebases. It is above 200ms/div that the meter does not update. Any ideas?
- Meter Updates 1.psd
- (9.95 KiB) Downloaded 365 times
- Meter Updates 2.psd
- (10.69 KiB) Downloaded 346 times
Last edited by Mech on Wed Apr 16, 2008 8:16 pm, edited 1 time in total.