Purchased the picoscope 2205A with two probes included. But when I want to calibrate a probe,
P6060, I am facing problems when I use an ordinary screwdriver and I do not want to ruin the probe.
Tried to find out which kind of tool I need but without success.
Can somebody tell me what kind of screwdriver I need?
Thanks.
which type of screwdriver do I need?
-
- Newbie
- Posts: 0
- Joined: Tue Feb 21, 2017 11:25 am
-
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Re: which type of screwdriver do I need?
Hi AnalogueMan,
There should have been a small tool included with the probes to allow you to do this.
If you have not received this, please e-mail support@picotech.com with your contact details or use a screwdriver with a small flat blade.
Regards,
There should have been a small tool included with the probes to allow you to do this.
If you have not received this, please e-mail support@picotech.com with your contact details or use a screwdriver with a small flat blade.
Regards,
Hitesh
Software Dev. Engineer
Software Dev. Engineer
-
- Newbie
- Posts: 0
- Joined: Tue Feb 21, 2017 11:25 am
Re: which type of screwdriver do I need?
Mea Culpa! I completely overlooked that little plastic bag with that small tool.
Must be my age, sorry
Thanks for your reply.
Must be my age, sorry

Thanks for your reply.
-
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Re: which type of screwdriver do I need?
I suppose it can be overlooked - glad you found it! 

Hitesh
Software Dev. Engineer
Software Dev. Engineer