problem in PicoLog with ADC200

Forum for discussing PicoLog
Post Reply
Guest

problem in PicoLog with ADC200

Post by Guest »

Hello,

I am using ADC 200 along with Wincapp and PicoLog softwere. I am using this system to monitor the current and voltage flowing through the electrochemical cell. I have attached a duel cathode reverse pulse rectifier to this system.

I found that the current noted by Picolog softwere is not same as that of shown by rectifier. I checked the system and think that current shown on the panel of rectifier might be the correct one. So something is worng on the PicoLog. Can any body please help me to get accurate current voltage graph.
Thank you

picojohn
Advanced User
Advanced User
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm

Post by picojohn »

Hello Guest,

Could you explain what Wincapp is, and also, how you are connecting the ADC-200 to monitor current and how PicoLog has been setup.

If you could send a copy of the .plw file from your recording session to support@picotech.com for my attention, that may also be useful.

Regards
John

Post Reply