Channel A of 5243A shows wrong waveform

[egonotto]

The some waveform but channel A is wrong

Hello,

I take a 1kHz waveform from the generator of my PicoScope 5243A and use a BNC tee to connect the generator to channel A and channel B of the PicoScope 5243A

The waveform of channel A is wrong. The low frequencies are damped.

Best regards
egonotto

PS: Sorry for first incomplete post.

[egonotto]

Hello,

I found whats matter.

The contact from center pin of connector channel A to PCB has almost 300 kOhm.

Best regards

egonotto

[Gerry]

Hi egonotto,

I just noticed your answer here (I replied to your other post).

If you want your PicoScope repaired you can send us the serial number for it, along with your full postal address, and we will start the returns process for you.

Regards,

Gerry

[egonotto]

Hi Gerry,

thanks.

I have fixed the problem with a soldering iron.
Now it looks fine (I reset colors to default).

Best regards
egonotto

[Martyn]

We do not recommend repairing the scope yourself, once opened it can no longer be guaranteed to meet published specifications, and any subsequent issues would not be covered by the 5 year warranty

However in this case it looks as if the repair has been effective, and you have a fully working scope