How to improve transfer speed on Rapid Block mode?

Post your MATLAB discussions here
Post Reply
Sairy
Newbie
Posts: 0
Joined: Mon Dec 28, 2020 10:08 am

How to improve transfer speed on Rapid Block mode?

Post by Sairy »

Hi,

I created data acquisition application using Rapid Block mode.
Trigger and memory segmentation are worked fine on each measurement but the transfer speed above 100 memory segments is slower than same size (x100 serialized) on Block mode.
How to improve the transfer speed on Rapid Block mode?

Thank you.

Gerry
PICO STAFF
PICO STAFF
Posts: 1145
Joined: Mon Aug 11, 2014 11:14 am

Re: How to improve transfer speed on Rapid Block mode?

Post by Gerry »

Hi Sairy,

Could you do the following;

1/ Could you tell us, in detail, the method that you used to determine this.
2/ Could you post the exact results that you found.

Regards,

Gerry
Gerry
Technical Specialist

Sairy
Newbie
Posts: 0
Joined: Mon Dec 28, 2020 10:08 am

Re: How to improve transfer speed on Rapid Block mode?

Post by Sairy »

Hi Gerry.

I am sorry, but this is my mistake.
The transfer time was measured including the trigger time of the device under test.
PicoScope works fine.

Could you please close this post?

Regards,

Thank you.

Post Reply