PT-104 temperature fluctuation

Post any questions you may have about our current range of USB data loggers
Post Reply
Vladimir Krzalic
Newbie
Posts: 0
Joined: Fri May 31, 2024 9:19 pm

PT-104 temperature fluctuation

Post by Vladimir Krzalic »

I have observed a strange issue that would like to share and possibly find out the reason for:

However I connect any of the 4 1/10 DIN pt-100 Pico sensors that I have, channel 1 seems to have lower temperature deviation comparing to others. For example, I put all 4 sensors together tied up and put into a constant temperature water bath with stirrer, leaving for the equilibrium for at least an hour. It can be observed on the logged charts that channel 1 has visibly better stability than the rest. I've tried all four sensors on channel 1, so there seems to be no difference in which sensor is plugged in.
Can someone explain such behavior? I'm out of options and have limited experience with the unit as it is still rather new and I am still learning all of its capabilities.
Attached you can find the log files and here are the few screenshots:

Image

Image
Attachments
15 May 2024 13-41-09.picolog
(39.5 KiB) Downloaded 99 times
15 May 2024 12-26-07.picolog
(32 KiB) Downloaded 102 times
15 May 2024 11-51-31.picolog
(34 KiB) Downloaded 95 times
15 May 2024 11-15-59.picolog
(79 KiB) Downloaded 92 times
15 May 2024 10-51-14.picolog
(48.5 KiB) Downloaded 103 times

Martyn
Site Admin
Site Admin
Posts: 4552
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: PT-104 temperature fluctuation

Post by Martyn »

Please make sure that Noise Filtering settings are the same for all channels. Currently you have this enabled dfor Channel 1 but off for the other Channels.
Martyn
Technical Support Manager

Post Reply