Forum for discussing PicoScope version 6 (non-automotive version)
- Posts: 0
- Joined: Fri Mar 13, 2015 10:27 am
When I capture a measurement with the picoscope software (without saving) and pull off the usb connection, then the software tries to reconnect the device and discards the captured data. Is there a possibility to prevent this behaviour or to restore the "last" captured signals? Of course there is no need to pull off the usb cable during a measurement, but sometimes there are situations where the connection suddenly gets lost (for example due to a pc error or the contact loss due to mechanical vibrations).
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Our Development Team are aware of this issue so I have added your comments to an existing bug report.
In streaming mode captures, the data is in PC memory so it should be possible to save this to disk in the event of losing the connection. In block/rapid block mode captures, the data is still on the device, but the software shows an aggregated view (min/max data values) so it is not possible to recover the raw data.
Software Dev. Engineer
- Posts: 0
- Joined: Mon Nov 28, 2022 4:18 pm
I have a similar problem and therefore wanted to inquire if this problem could be fixed? Can anyone help me further?
We used the PicoScope 6824E, if this helps.
- Site Admin
- Posts: 4277
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
You need to look at the reasons why the USB connection is being interrupted. Please contact email@example.com and provide full details of what is happening for you.
Technical Support Manager