I am using the Picoscope 5443D for data acquisition application using LabView 2019 for measuring the pulse width of 100 micro seconds and send it for analysis. After completion of analysis it will again start the acquisition foe next pulse.
Data aqusition is doing with Rapid block bulk mode. When initialize the auto trigger time to other than zero, it is working perfect. When initialize the auto trigger time to zero, in simple edge trigger, it is still in the ready block while loop even though stop command pressed.
Now we would like to stop the acquisition of picoscope while it is waiting for the trigger.
Post your LabVIEW discussions here
1 post • Page 1 of 1