using sampling scope in real time mode.

Post discussions on applications you are writing
Post Reply
rezafard
Newbie
Posts: 0
Joined: Sun Feb 16, 2020 7:08 pm

using sampling scope in real time mode.

Post by rezafard » Sun Feb 16, 2020 7:22 pm

I have a picoscope 9200, sampling scope. for an application i need it to be in real time mode, for a single signal that is not symmetric, it should get enough point that we can make a histogram for the signal.
as i know the maximum conversion rate in real time mode for this scope is 100MSPS. this is good rate! but i could not find any way in the scope's software to use this scope in real time mode. i hope some one help me.

Martyn
Site Admin
Site Admin
Posts: 3768
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: using sampling scope in real time mode.

Post by Martyn » Mon Feb 17, 2020 10:38 am

The 9200 series sample at 100kS/s , they can't be used for real time data capture.
Martyn
Technical Support Manager

Post Reply