Test and Measurement Forum

Picolog 1012 voltage values reading problem

Post any questions you may have about our current range of USB data loggers

Picolog 1012 voltage values reading problem

Postby Ales » Wed Sep 28, 2011 3:06 pm

I have a problem with PicoLog1012 unit. It is connected to a torque rig. Voltage values shown by PicoLog software do not match voltage values coming out from the rig (measured by a multimeter). The software shows about 10times lower values. When the voltage values coming out from the rig are very small (about 0.001) the picolog set does not detect them until the coming out values are about 0.03V. Is it the software setting or the unit problem. Also, is there a possibility how to tweak the picolog unit sensitivity in the software?
Thank you for any help
Ales
Newbie
 
Posts: 0
Joined: Wed Sep 28, 2011 2:47 pm

Re: Picolog 1012 voltage values reading problem

Postby Hitesh » Fri Sep 30, 2011 2:45 pm

Hi Ales,

Please can you e-mail this to support@picotech.com ?

It would be helpful to have information on any connections to the terminal board, any resistors/components used.

You can use a look-up table in the PicoLog software to scale values.

Regards,
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2058
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to USB PC Data Loggers

Who is online

Users browsing this forum: No registered users and 0 guests