Test and Measurement Forum

PicoLog 1000 measuring/ data transmission frequency

Post any questions you may have about our current range of USB data loggers

PicoLog 1000 measuring/ data transmission frequency

Postby student1 » Mon Sep 26, 2011 11:18 am

Hello,

I have a question concerning the data transmission frequency of the PicoLog1216 Datalogger:
We are measuring pressures in a pipe with 8 pressure sensors. Frequency 1 ms.
These 8 sensors + one anemometer is connected to the data logger.

In the software we set a frequency of 20 ms. (see attached .plw).
But somehow, we are only getting a new value every 0.6s =600ms.

How can I get a value from every sensor every 20 ms? Which settings must I change?
Does the logger maybe need too much time for switching from one to the next channel?

Thank you for your help!
Regards,
student1
Attachments
1.PLW
(17.7 KiB) Downloaded 125 times
Last edited by student1 on Tue Oct 04, 2011 12:42 pm, edited 1 time in total.
student1
Newbie
 
Posts: 0
Joined: Fri Sep 23, 2011 7:22 am

Re: PicoLog 1000 measuring/ data transmission frequency

Postby Martyn » Tue Oct 04, 2011 9:37 am

Check what you have set for Settings->Sampling->SamplingInterval. If you are unsure what this means you will find an explanation in the online help accessible from the pop up window.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2339
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to USB PC Data Loggers

Who is online

Users browsing this forum: No registered users and 0 guests