Test and Measurement Forum

time data acquisition

Forum for discussing PicoLog

time data acquisition

Postby FogGio » Wed Sep 14, 2011 4:01 pm

Hi I'm a new user
I'm try to use Picolog to detect the time of flight of a wave.
In particular I want to detect automatically the time distance between CH. B trigger (or between vertical cursor) and the maximum peak of CH. A,
The max peak position will vary in a defined time range (between two vertical cursor).
Is there any esay way to do it ?
If it's possible I need also to storage the collected value.
THANKS
FogGio
Newbie
 
Posts: 0
Joined: Wed Sep 14, 2011 3:10 pm

Re: time data acquisition

Postby Martyn » Wed Sep 21, 2011 8:51 am

It is not possible to automatically make measurements between two waveforms on different channels using the PicoLog software. To achieve this you either need to manually make the measurements or would need to look at writing your own software to analyse the data.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2349
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoLog

Who is online

Users browsing this forum: No registered users and 0 guests