Test and Measurement Forum

Transfer function measurement with 4227

Post any questions you may have about our current range of oscilloscopes

Transfer function measurement with 4227

Postby jwasys » Fri Sep 09, 2011 9:28 am

Hello forum members,

I have a question regarding the 4227. I am planning to measure the transfer function of a network, and was thinking to do this with the 4227. The idea would be to fill the AWG with an appropriate waveform, arm the scope and then trigger both.

Bandwidth needed is 5Mhz.

After rereading the spec I see the AWG has a bandwidth of 100KHz. But what comes out if I put in say a 5Mhz square ? Will anything come out or is there a steep filter.

Maybe anyone can suggest a better solution.

Thanks,

Arian
jwasys
Newbie
 
Posts: 0
Joined: Fri Sep 09, 2011 9:18 am

Re: Transfer function measurement with 4227

Postby Martyn » Mon Sep 12, 2011 1:46 pm

Whilst the 4227 may be suitable for measuring the transfer function of your network, the AWG would not be suitable for generating a suitable waveform at 5MHz. For that you would need to consider an alternative signal source or use one of our other scopes.

You may wish to discuss these requirements directly with the team, support@picotech.com

Kind regards,
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2339
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 1 guest