Test and Measurement Forum

Triggering in Labview\ adc200_set_trigger

Post general discussions on using our drivers to write your own software here

Triggering in Labview\ adc200_set_trigger

Postby eeniu@hotmail.com » Thu Jun 24, 2004 8:18 pm

I am making a user interface through labview to take measurements of the signal coming from the pico. I used the example interface you provide, but it does not have a set trigger library in the example. Is there anyone that has accomplished this and if not is there anyone that knows the correct approch.

Postby markspencer » Fri Jun 25, 2004 7:22 am


After a few requests from other companies I have created a vi that does have triggering incorporated. If you send an email to:


request adc200t.zip

Best regards,

Mark Spencer
User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests