Test and Measurement Forum

Sensor information with EL008

Sensor information with EL008

Postby jimmac » Fri Jul 15, 2011 12:34 pm

Hello,

I am trying to set up a simple system - temp/humidity - with an old EL008 logger. When I try to select the sensors, in the drop down menu I can only see 'Mains 240', 'mains on' ect...., but no 'Temp sensor' as I would expect. Is the logger too old for the software now?

Help?

Thanks,
Jim.
jimmac
 

Re: Sensor information with EL008

Postby ziko » Thu Jul 21, 2011 11:14 am

Hi Jim,

The software will work with the EL008, you have to autoconfigure so the logger can find the devices that are connected to it, then you got to locations to add the channels and then you click on programme to pass configuration to the logger.

To get into this section you need to select, Settings->Configuration-> Change and then Advanced. Then select Normal if a window pops up.

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to Hardware

Who is online

Users browsing this forum: No registered users and 0 guests