Test and Measurement Forum

ADC-11 I/O pin allocation

Post any questions about our parallel port products

ADC-11 I/O pin allocation

Postby Heath » Tue May 03, 2011 12:36 pm

Hi, Maybe this is a dumb question but I have searched all the documentation for the ADC-11 and cannot find the pin allocation table for the channel inputs, please can you help. Many thanks.
Heath
 

Re: ADC-11 I/O pin allocation

Postby ziko » Wed May 04, 2011 2:33 pm

Its a good question! ITs not in the main manual, the USB ADC11 will have the pin layout ontop of the logger itself, on the parallel ADC11 and the USB ADC11 there is a terminal board pin out in the terminal board manual:

http://www.picotech.com/document/pdf/ad ... s-en-5.pdf

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: ADC-11 I/O pin allocation

Postby Heath » Thu May 12, 2011 3:29 am

Hi Ziko,
Many thanks for your reply. I have looked in the terminal board manual but it does not actually give the 25pid D connector pin out. I assume channels 1 to 11 are on pins 1 to 11 but what about the digital out and the ground?

Best Regards Heath.
Heath
 

Re: ADC-11 I/O pin allocation

Postby ziko » Thu May 12, 2011 5:00 pm

Hi this is the USB ADC11 I/O pin, the parallel ADC11 will be the same apart from the fact it has only one Digital Output.

Kind regards
Attachments
adc11inputs.jpg
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests