Connecting TC08 with MCU

Post general discussions on using our drivers to write your own software here
Post Reply

Connecting TC08 with MCU

Post by MAX » Thu Apr 01, 2004 1:54 am

I am using 4 set of TC08 for 2 years and am very happy with it together with my PC/Window platform. Now I want to extend it to 10 unit but it is very expensive if every TC08 need to connect to a computer. Want I want to do is to connect the TC08 to a microcontroller (MCU) through UART (RS232) to form a cheap solution. My question is on the protocol of the TC08, we use the library comes with the TC08 in VB/VC at the old day but protocol is needed if I want to communicate in MCU. Any body here (or Pico technical support ppl) can help me? Thanks.

User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer » Fri Apr 02, 2004 8:12 am


Thank you for your question. The TC-08 communication protocol is provided in the Help Manual under the heading:

Technical Information | Protocol

If you do not already have the help manual then it can be downloaded from here, as a .hlp file or .pdf.

Best regards,

Mark Spencer

Post Reply