ADC=100 Hardware not working

Having problems ? let us know the details here
Post Reply
BrianDSmith

ADC=100 Hardware not working

Post by BrianDSmith »

Software installs ok. Help->About shows 60k samples/sec maximum.

Meter will not display 1.5 volt battery connected to Input A. Scope display clips inputs, sine, square and triange show up as square wave. Deflection shows only 1/2 division deflection.

Frequency of display is ok, but all inputs are clipped to a square.

Is there a self-diagnostic proceedure?

Brian

mark

Post by mark »

Brian

Unfortunatley, there are no self diagnostic functions within the ADC100. However, your problem does sound like the ADC100 needs an adapter.

For more information, check out

http://www.picotech.com/support/viewtopic.php?t=63

BrianDSmith

ADC-100 problem

Post by BrianDSmith »

Mark

The adapter fixes the problem. Thanks.

I still cannot get the voltmeter to diplay any DC volts. The scope display shows a proper DC voltage is present. The AC voltmeter has the same problem. The scope display shows an AC voltage but the voltmeter display show zero volts.

Any help is appreciated.

Brian

Post Reply