Test and Measurement Forum

Long

Post any questions you may have about our current range of oscilloscopes

Long

Postby MarioFM » Wed Feb 09, 2011 4:37 am

I have purchased a picoScope series 2205 from you a few months ago.
For a project I am working on, I determined that the signal’’s frequency is around ~250 kHz. To be able to decode the signal I will need longer samples than what the scope can hold as a waveform.
I figured out that between buffers there is some signal lost and I don’t think that a continuous signal can be reconstructed concatenating several waveforms.
Is there some software that run with the scope to get a longer signal? (around a few seconds worth of signal)
What are the options for data recorders?
20100917-2120.psdata
This is a sample of the signal
(196.65 KiB) Downloaded 107 times
MarioFM
 

Re: Long

Postby ziko » Thu Feb 10, 2011 3:01 pm

Hi there will be an associated delay between buffers, the only way to get round this is to write your own software really.

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests