Test and Measurement Forum

Converter does not restart after reading

Converter does not restart after reading

Postby Jaap » Mon Jan 31, 2011 6:33 pm

I have just installed a EL 005 datalogger with 4 EL001 triple temperature loggers connected to it. I am able to program the device numbers to the loggers. When I try to read the converter number I finds the converter, displays the correct number. Then I click OK. When the logger wants to restart I get the following error:

"Restarting the logger Operation Failed".

I am getting this error on every converter. I have tried the newest software. A hard reset of the logger and also removed the battery. Nothing helps. What can I do??
Jaap
Newbie
 
Posts: 0
Joined: Mon Jan 31, 2011 6:25 pm

Re: Converter does not restart after reading

Postby ziko » Thu Feb 03, 2011 3:43 pm

Hi yes you need to upgrade the firmware of the logger, if you go to Utilities and then choose Logload then follow the instructions, disconnect all converters, you will need a paper clip. For more help follow this link below, it has the steps that you will see on the latest software but before it was made as a GUI

topic4038.html

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to Hardware

Who is online

Users browsing this forum: No registered users and 0 guests