Test and Measurement Forum

Are there any diagnostic tests to run on my adc-212?

Post any questions about our parallel port products

Are there any diagnostic tests to run on my adc-212?

Postby coolwood » Tue Dec 28, 2010 12:51 am

It was working just great and when I connected the signal ground I got a ground fault. Now when I try use it I get the "ADC-212 not connected" error message. I checked all the cables and connections. The power light is lit. Not sure of what to do next. Is there a place I can sent the unit for repair? Are there any other tests I can run to find out why the software does not recognize the scope.

Thanks
coolwood
Newbie
 
Posts: 0
Joined: Tue Dec 28, 2010 12:40 am

Re: Are there any diagnostic tests to run on my adc-212?

Postby gruntman » Tue Dec 28, 2010 9:12 pm

Coolwood,

Since I'm assuming that you didn't make any changes to the computer setup (port changes etc), that this would indicate that some components on the scope/USB-Parallel adapter have been damaged. The unit will have to be sent back to Pico for repairs.

If you wanted to do this you need to send an email to support@picotech.com detailing the problem and your return address along with the serial number of the unit. They will let you know what steps need to be done.
Regards,

Richard Boyd
Crag Technologies, Inc
http://www.pc-oscilloscopes.com
gruntman
Guru
Guru
 
Posts: 109
Joined: Thu Sep 28, 2006 3:50 pm


Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests