Measure phase angle?

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
dt99idr
Newbie
Posts: 0
Joined: Mon Nov 29, 2010 10:26 am

Measure phase angle?

Post by dt99idr »

I have a quardature signal I'm trying to measure and need to measure the phase angle. Is there anyway I can get picoscope to do this?
Also I believe the duty cycle measure two complete cycles and then averages. It is possiable for it to actually measure a single pulse so I can get a true max/min duty cycle?

Thanks,

Ian

P.S. I use Picoscope 5204

Ortenzi
Newbie
Posts: 0
Joined: Sat Nov 20, 2010 3:47 pm

Re: Measure phase angle?

Post by Ortenzi »

Take a look at my post: I've attached a file that has some controls to take measurements. Unfortunately, doesn't works with my PICOSCOPE 4424, could be run with your ...

Very unsatisfied with the PICOSCOPE 4424 ... posted by Ortenzi.

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: Measure phase angle?

Post by ziko »

Hi dt99idr,

We do not do direct measurements for the phase angle. In temrs of the duty cycle I am looking into this for you.

Ortenzi I have responded to your post as well.

Kind regards
Ziko

Technical Specialist

Post Reply