Test and Measurement Forum

LabVIEW driver for ADC 200/20

Post any questions about our parallel port products

LabVIEW driver for ADC 200/20

Postby grahamwebb2000 » Thu Nov 04, 2010 3:27 pm

I am really struggling to get continuous data recording in LabVIEW from my Pico 200/20.

I have tried the examples (triggered and not triggered) which only capture a defined number of samples, they work. But occassionally crash the Picoscope. I then resorted to going through each function (from the manual) one at a time to see if the return values are correct. Every time the picoscope does crash I have to close down LabVIEW and re-start, the 'clear all device associations' in LabVIEW doesn't resolve that.

Could someone advise me on the correct flow of commands please? Or perhaps look at my LabVIEW code?

Many thanks
Graham
grahamwebb2000
Newbie
 
Posts: 0
Joined: Mon Nov 01, 2010 2:15 pm

Re: LabVIEW driver for ADC 200/20

Postby Chris » Wed Nov 10, 2010 3:18 pm

Hi Graham

If you send your LabView code to

support@picotech.com

with a description of the problem, we'll take a look at it for you.

-Chris.
Chris
Site Admin
Site Admin
 
Posts: 169
Joined: Tue Aug 17, 2010 9:00 am
Location: St. Neots


Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests