Test and Measurement Forum

convert USB TC08 coding to Serial TC08

Post general discussions on using our drivers to write your own software here

convert USB TC08 coding to Serial TC08

Postby shnteb001 » Tue Sep 21, 2010 3:22 pm

Hi
Im not so good with matlab. But I found a program for a USB TC-08 and need to convert it to be able to use with serial TC-08.
Here is the code. If anyone has code or somthing that could help pls pm me. Thanks
---start here---
if ~libisloaded('usbtc08')
disp('Matlab: Load usbtc08.dll')
loadlibrary('C:\TC08\usbtc08.dll','C:\TC08\usbtc08.h')
disp('Matlab: dll loaded')
disp('')
else
disp('Matlab: dll already loaded')
disp('')

end


htemp=calllib('usbtc08', 'usb_tc08_open_unit') % open communication with TC-08

ok=calllib('usbtc08','usb_tc08_set_channel', htemp,int16(1),int8('T')) %setup a single channel

%-------------------------------------------------------------------------
x=single(3);
y=int16(3);
xp = libpointer('voidPtr',x);
yp = libpointer('voidPtr',y);
for loop =1:100
[a,data(loop),cthing]=calllib('usbtc08','usb_tc08_get_single',htemp, xp,yp, 0);
pause(0.01)
end
%-------------------------------------------------------------------------

ok=calllib('usbtc08','usb_tc08_close_unit',htemp);%close comms with TC-08
shnteb001
Newbie
 
Posts: 0
Joined: Fri Sep 17, 2010 9:32 am

Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests