Pico Log for more than one device?

Which product is right for your exact requirements
Post Reply

Pico Log for more than one device?

Post by huaining » Wed Jun 23, 2010 9:51 am

I have a ADC 24 for voltage signal recording. Now I am interested in the Dr DAQ for temperature, pH, light and O2 recording. It seems Dr DAQ use PicoLog as data recording as well. Will it conflict with the ADC 24 data recording in the same computer? How to do with it?

BTW, can I ask about the DD103 Oxygen sensor, is it only use in the air? What's the dimension of the probe? Do you have O2 probe with smaller size like 2-5mm diameter also suitable for water-based samples?

Do you have smaller size of pH probe as well? like 2-5mm diameter?

Thanks a lot!

Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: Pico Log for more than one device?

Post by ziko » Tue Jul 13, 2010 2:42 pm

Hi it is theoretically possible to do so, however the DrDaq is a parallel ported product and as such it cannot be guaranteed. Try to the use multiple converters feature in PicoLog. You may need to re-install the software again and tick the "Install for other devices" tickbox so that the drivers for both products are present.

In terms of the Oxygen sensors, this is the only we sell, and the dimensions are:

Length of about 8cm,
the circumference at the top is about 2.5cm
the circumference at the base is about 3.5cm

Please have a look at the link below to get a better idea of what the sensors looks like.


Kind regards

Technical Specialist

Post Reply