Test and Measurement Forum

startup settings

Post any questions you may have about our current range of oscilloscopes

startup settings

Postby richy » Thu May 20, 2010 7:40 pm

4224...Re start up setting; esp in FFT mode: I notice there is only one load/start spectrum setting available on boot up. Is this correct ? I think this applies to all Pico 6 software in general.

I would love more options to be able to start up and load different scalings.

richwalters
richy
 

Re: startup settings

Postby PeterF » Thu May 27, 2010 2:19 pm

Hi,
There is only one "Default" start-up setting but you can have many different settings saved as "Settings" files (.pssettings). These can be double-clicked to start-up PicoScope6 in that mode.
Just set-up as you wish and go to "Save Current Waveform as" then select "Settings Files (.pssettings)".
Regards,
PeterF.
PeterF
Zen Master
Zen Master
 
Posts: 435
Joined: Thu Jun 07, 2007 10:53 am
Location: Cambridgeshire


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests