Post-Trigger-Time in Measurement "Maximum"

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Philipp

Post-Trigger-Time in Measurement "Maximum"

Post by Philipp » Wed May 12, 2010 1:08 pm

Hi there,

I need to measure the time it takes the signal of Channel B to get to its Maximum after the trigger occured. The "trigger signal" is put on Channel A.
The measurement "Maxium" only gives the y-coordiante (Voltage) of the maximal Voltage, not the time. Is there any possibility to get the time in this measurement?

Thank you for your help!

PeterF
Advanced User
Advanced User
Posts: 435
Joined: Thu Jun 07, 2007 10:53 am
Location: Cambridgeshire

Re: Post-Trigger-Time in Measurement "Maximum"

Post by PeterF » Wed Jun 16, 2010 3:13 pm

Hi,
I am afraid that you will have to place a cursor on the point of maximum voltage if you wish to time it. The time will be displayed in a text box but not as a normal automatic measurement.
Regards,
PeterF.

Post Reply